ITT general controls gas valve with a Honeywell TS810B1007

Check out some similar questions!

I have an old heater. The label underneath the case states Model G-36-S.D. input rating--35,000 BTU; output rating--24,500 BTU; equipped for use with natural gas. Holly Division of Leah Siegler, Inc. The unit (I believe it's the heater looks like it was replaced with another unit. The small unit...

ITT General Controls thermostat went out [ 5 Answers ]

Hi everyone, I stumbled across this site today after my thermostat went out. It's a T80BV100 ITT General controls thermostat. I disconnected it from the wall and exposed two black unlabeled wires. For the record it says for use with millivolt and B54M gas valve only. My question is...

Itt general controls thermostat [ 2 Answers ]

Good morning! I want to replace my ITT General Controls thermostat with a programmable one in order to save some gas. I have an old gas in-floor furnace with the ITT thermostat Cat No. #T80AV100. (Actually the printing on the back of the thermo cover is not very good, so I am inferring that...

Need wiring schematic for an old itt general control gas valve [ 12 Answers ]

Help, I need wiring info for an old ITT general control gas valve on an outdoor swimming pool heater. The valve has 4 terminals, 2 labeled thermostat and 2 for the millivolt generator. I understand the safety devices get wired in series but I am not sure how the on/off switch and thermostat get...

Wiring for new Honeywell thermostat from ITT General Controls [ 10 Answers ]

I have an old ITT General Controls (mercury switch) thermostat for our electric furnace. I am trying to replace it with a Honeywell RTH230b thermostat. The old wiring has four wires (two white and two red) which are attached to screws labeled "F, H1, H2 and V". Looking at the wiring diagram on...

View more questions Search

Check out some similar questions!

Add your answer here.