Ask Experts Questions for FREE Help !
Ask
    Lydia1's Avatar
    Lydia1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 12, 2014, 03:11 PM
    Help on installing new starter B&S toro zero turn
    I ordered a new B&S starter. It came with some new hardware, ground strap and including instructions to install a band and rectifier? Help this is a used mower and 2002 and it has had starter replaced before.

    However, it did not have a ground strap, band or rectifier attached to starter. Could the last installer taken off, or is this something new. I cannot figure it out. Is there a manual or video to show me how to re install? Thank you for you help.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Sep 12, 2014, 07:51 PM
    Hi,
    I am not sur, but the ground strp could be need to be reused. You do not provide and modelnumber or part number, so how can one tell?
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toro lawn mower starter [ 1 Answers ]

My electric starting toro lawn mower will crank up and the gear spins good and strong. But it won't go down to the fly wheel gear. I replaced the nut and gear. The cork screw that comes up from starter motor looks OK. That's a 65 dollar part. I don't know if the top of the cork screw gear is...

What would cause a Toro Zero turn not to start? [ 0 Answers ]

Our Toro will not start... we tested battery, ignition switch, pto,kill switch on seat, replaced solenoid and it still will not start... if you attempt to bypass and start with solenoid and battery it attempts to crank but will not throw a spark to spark plugs.. spark plugs are good what else would...

Toro lawn mower 200016 recoil starter is stuck. I am unable to pull the chord. [ 0 Answers ]

I have a Toro lawn mower 200016 recoil starter is stuck. I am unable to pull the chord anymore. Prior to now, there have been instanced where the chord would not retract. However, as of today, it will no longer allow me to pull it out. Any ideas?

Replace starter cord toro snowblower ccr2000 [ 2 Answers ]

Some people are still fixing lawnmowers, God bless you ! I just got my snowblower out, got it started, ran pretty well (it's up and down, which makes me think that some engine components are getting wet, but that's another story. After dying in a huge drift, the starter cord broke, deep, deep...

Toro pull starter [ 2 Answers ]

Toro recycler pull start pulls almost all the way out before engageing the engine to start. How do I repair?

View more questions Search