Ask Experts Questions for FREE Help !
Ask
    tstreng's Avatar
    tstreng Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 15, 2014, 07:05 AM
    Just installed new Pto Clutch on L130 John Deere and won't work. Can you help me?
    PTO Clutch will not engage. Installed properly.
    tstreng's Avatar
    tstreng Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jul 15, 2014, 07:32 AM
    I have a L130 John Deere and having problems with the PTO clutch not engaging.
    I have a L130 John Deere and having problems with the PTO clutch not working.
    I installed a new clutch and still will not engage. When I get of seat while running the engine shuts off so I figure its not the switch. Could it be the wiring? Can anyone give me a answer on this.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #3

    Jul 18, 2014, 11:06 PM
    Hi,
    If the clutch is working, it should "clunk" with the key on and you on the seat when the button is pulled out; engine does not have to be running. Check for a broken/bad wire near the clutch itself or in the rear harness along the frame on the right side inboard of the right rear tire.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does anyone have a wiring diagram for clutch on john deere l130 [ 1 Answers ]

I need a wiring diagram to reconnect wires on clutch. Wires were broke.

My john deere l130 mower deck will not start. Replaced the pto switch. Help! [ 3 Answers ]

My john deere l130 will not start. The engine runs fine. I replaced the pto switch, but it still will not start. Can it be anything other than the electrical? Checked the continuity to the pto and it was fine.

John Deere Lawn Tractor 145 PTO Clutch [ 0 Answers ]

I have a John Deere 145 Serial Number GX0145A016096 Engine Number 051209YG15224 Date of Manufacture 22 Dec 2005 I was mowing the mower suddenly stopped. At first, I found a dead fuse. After changing the fuse, the starter would not crank the engine. The only noise was a "clank". I could not turn...

L130 John deere mower not engaging deck when pto knob engaged [ 2 Answers ]

The engine runs fine for as long as I want it to until I pull that knob. Then it sounds like it want s to work and just dies. The belts don's spin at all when thi is occurring. Primary wheel located beneath the engine which drives the belts doesn't seem to spimove the belts. I am considereing...

John Deere L120 Clutch / PTO (GY20878) [ 2 Answers ]

How do I remove the bottom bolt to replace the PTO. The crankshaft keeps rotating with the bolt. Is there a special tool to keep the shaft from moving.

View more questions Search