Ask Experts Questions for FREE Help !
Ask
    IMB14's Avatar
    IMB14 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 8, 2014, 01:45 PM
    Can gas can be cleaned with detergent after having diesel in it?
    If I clean a gas can previously used for diesel fuel with Dawn, will it be safe to put unleaded gas in it for other uses?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jul 8, 2014, 02:11 PM
    Rinse it with gasoline 2X and you don't need to use Dawn. Gasoline and Diesel are misciable in each other.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #3

    Jul 8, 2014, 02:42 PM
    Rinse with gas and reuse.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sewage Gas Odor in Basement in Warm Weather. We've already cleaned drains in house [ 0 Answers ]

We have had an odor for a few months now coming from the basement. We have added bleach & water to all the drains in house hoping that would fix it. We add water daily to drain in basement floor to help the P-trap drain effectively. The smell comes back when weather is above 40 degrees. The...

What gas air heater do I use for detergent spray dryer? [ 0 Answers ]

I am building a small spray dryer, 1-meter diameter by 6-meter height, drying chamber dimension. I need 400 deg centigrade air temperature in the drying chamber. The product is detergent. I got a hint that Indirect Gas Air Heater may not easily get 400 deg C air temp, and if I use Direct Gas Air...

I have an Amana gas pac, it cycles on and off. Cleaned sensor, still not working righ [ 3 Answers ]

My gas pac keeps cycling on and off. I cleaned the flame sensor and that did not solve the problem. After about four tries it will shut down completely. Burners look OK. If I remove the access door it will burn like its suppose to but once I put the door back on it starts to cycle again

Cleaned Flame Sensor & Reset Gas. Still Kicking Off. Please Help! [ 0 Answers ]

I have a Trane XR80 and I cleaned the flame sensor, turned off gas for 5+ minutes and works for a little bit but then it goes back to the routine where the flames kick on for a few seconds and go right out. What else is there to do? Thanks in advance.

Kenmore 110-74672400 Gas Dryer WIll Not Heat After I cleaned all the Vents out! [ 1 Answers ]

All I did today was tilt the dryer forward while I disconnected the vent lines and cleaned all of them from the back of the dryer all the way to the outside of the house. Could I have screwed up the Pilot by tilting it and keeping it tilted for such a long time? I thought I would have made the wife...

View more questions Search