Ask Experts Questions for FREE Help !
Ask
    G_Money's Avatar
    G_Money Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 27, 2012, 11:22 AM
    I have an Amana gas pac, it cycles on and off. Cleaned sensor, still not working righ
    My gas pac keeps cycling on and off. I cleaned the flame sensor and that did not solve the problem. After about four tries it will shut down completely. Burners look OK. If I remove the access door it will burn like its suppose to but once I put the door back on it starts to cycle again
    SeattlePioneer's Avatar
    SeattlePioneer Posts: 97, Reputation: 9
    Junior Member
    		  
    #2

    Jan 27, 2012, 12:32 PM
    Take the cover off the burner compartment of the furnace. Obtain the make and model of the furnace off the rating plate in the burner compartment and post it here.

    Observe the sequence of events that occurs at the furnace when you turn up the thermostat and post that sequence of events in order and in detail.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Jan 27, 2012, 04:05 PM
    It works with which door removed, the combustion door, or the blower door? Ive got a couple thoughts, but need more info, specifically the info SP asked for.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #4

    Jan 27, 2012, 06:07 PM
    Sounds like you have a limit switch that is opening due to lack of air flow. Count the blinks of the lights on the control board. The code should be located on the blower door telling you what the fault is.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Outside gas pac (natural gas) has lot of soot on furnace [ 0 Answers ]

Seems like a lot of soot around on unit above exchanger. Noticed a lot of soot on eve of house this past winter. Heat and a/c is working OK. Just trying to head off any problem. I have a handicapped son and don't want any sudden break downs... undefinedAny help please.

Cleaned Flame Sensor & Reset Gas. Still Kicking Off. Please Help! [ 0 Answers ]

I have a Trane XR80 and I cleaned the flame sensor, turned off gas for 5+ minutes and works for a little bit but then it goes back to the routine where the flames kick on for a few seconds and go right out. What else is there to do? Thanks in advance.

Hello there! I cleaned the flame sensor [ 0 Answers ]

Hello there I cleaned the flame sensor now the furnace won’t start at all, is there anything else I can do before I call the serviceman? Thanks My furnace keeps turning on and off every minute. The flam comes on and than you can here a puff, than it shuts off. Keeps repeating over and over...

Ruud gas pac [ 1 Answers ]

What will cause a gas pac to blink with one red light and only one burner will come on. Wait a little while and all burners will come on. But at night it will not come on at all.

View more questions Search