Ask Experts Questions for FREE Help !
Ask
    mrelf's Avatar
    mrelf Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 24, 2014, 06:41 AM
    Have replaced heater box #27983 and upper limit thermostat #3390291, have no power to
    Have Kenmore 110.96576200 dryer, have replaced heater box #27983 and upper limit thermostat #3390291, have no power to either device. Where to now?? Dryer vent is open and clear.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Mar 25, 2014, 12:15 AM
    Did you use a meter to wire it up? If you did then you would have no problems. How did you test the components? New parts can be bad, too. Manuals: (Follow wiring diagrams with a meter.) https://dl.dropboxusercontent.com/u/...l%20Dryers.zip
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Im not getting power from my fuse box to the pump in the well and I have replaced the [ 0 Answers ]

I am not getting power to my pump in my well Im getting power from fuse box to pressure switch I bought new breakers and new pressure switch pump does nothing it worked for 2 days after putting in new pump but now nothing works can anybody help. My new pump does have 3 wires as my old had two and I...

Can the fan on a power vented gas hot water heater be replaced? [ 0 Answers ]

We have a power vented gas hot water heater that heats the water fantastically, however the fan is getting noiser and noiser my question is can you replace just the fan?

Replaced thermostat now heater is not blowing hot [ 1 Answers ]

Replaced thermostat now heater is not blowing hot or very hard / I thought I had the power off when replacing the thermostat but didn't and arked two wires / the temp rises but very slowly and no sure if that was because of the outside temp

Marley fan forced baseboard heater power to limit switch is it bad? [ 1 Answers ]

Could it be the limit switch?

No power after thermostat replaced [ 3 Answers ]

Ok... I know better... but since I was dealing with low voltage... I figured no harm... WRONG! :eek: I should have turned off the breaker when replacing my thermostat... enough said. I replaced my thermostat (simple comfort 3001) with a honeywell RTH6300b because the simple comfort display was...

View more questions Search