Ask Experts Questions for FREE Help !
Ask
    tennsany1's Avatar
    tennsany1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 29, 2013, 04:42 PM
    State Select Natural Gas Hot Water Heater
    The exhaust blower on my State Select natural gas hot water heater will not turn off (runs continuously whether heating burner is on or off). Is the air pressure switch bad or the manual hi pressure switch bad, or, does something else need replaced. Tried resetting by disconnecting electricity. Nothing works.
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    Nov 29, 2013, 06:49 PM
    Hi Tennsany

    In cases like this, you are best to contact state water heater company technical support directly:

    State Industries - Solid.State.

    Click on the CONTACT icon at the top of the page.

    You will need the water heater model number, the water heater serial number and a good multi.-meter when you connect up with them over the phone.

    State has great customer service... ;)

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troubleshooting state select natural gas water heater [ 0 Answers ]

My water heater is all of a sudden getting to hot .it is 6 years old .why would water get hotter out of all faucets with out touching gas valve ?

State Select Gas Hot Water Heater Pilot & Burner Goes Out [ 2 Answers ]

I have a Stat Select 50 Gal Gas Hot Water Heater made in 2005. Yesterday there was no hot water. The pilot light had gone out. I relit the pilot and the burner came on. This morning there was again no hot water. The pilot was out again and I relit it and turned on the burner. I noticed...

State Select Gas Water Heater? [ 1 Answers ]

I have been requested to install a drip leg/sediment trap on the gas supply to the water htr. The heater was installed in 2008.is this a code requirement now if it is does it need to be installed on a4yr.old installation

How do I jump start an exhaust fan on a state select gas hot water heater? [ 1 Answers ]

It has happened before and a repair person jumped it and ordered a thermacoupler but it has lasted a year. I want to try it again myself to see if I can avoid a bill. The pilot light is lit.

State Select Gas Hot Water Heater - main burner will not light [ 2 Answers ]

My main burner will not light. After the hot water heater power cycles three times, the hot water heater shuts down and the following error code is displayed: 100110 which the owner's manual says is System Lockout Things I have tried: Repositioned the igniter assembly several times...

View more questions Search