Ask Experts Questions for FREE Help !
Ask
    rsf_5410's Avatar
    rsf_5410 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 18, 2009, 08:28 PM
    State Select Gas Hot Water Heater - main burner will not light
    My main burner will not light. After the hot water heater power cycles three times, the hot water heater shuts down and the following error code is displayed:

    100110 which the owner's manual says is System Lockout

    Things I have tried:

    Repositioned the igniter assembly several times
    Replaced the igniter assembly
    Tried starting using different temperature settings

    Every now and then the burner will light but only for a few seconds.

    Can anyone help?
    ssubram's Avatar
    ssubram Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Nov 16, 2010, 09:10 AM
    I am having the same problem with my heater. Any chance you got yours resolved?
    bighead1's Avatar
    bighead1 Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Nov 17, 2010, 10:48 AM
    Try replacing the thermocoupling.. It's a cheap fix- probably less than $10.00. Sounds like it is failing. JG
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can't find where to light pilot on State Select Water Heater [ 2 Answers ]

I am having a horrible time finding the Hot Water Heater pilot on a State Select Hot Water Heater.

Unable to light pilot on "previously" winterized State Select gas water heater? [ 4 Answers ]

I'm a home inspector and today inspected a 4 year old home in which the bank had the home winterized.. We turned the gas on and were able to operate the kitchen range, and the gas furnace took about 15 minutes to lite with the electronic ignition continuing to try lite the furnace an eventually...

Water heater pilot light gets extinguished by main burner ignition. [ 1 Answers ]

Problem: Water heater pilot light gets blown out by main burner when it ignites. Background: About eight or nine days ago I installed a new Rheem LP gas fired water heater. I had to convert (change / install) the main burner jet and pilot light orifice to burn LP gas as well as change the...

State Select Hot Water Heater [ 4 Answers ]

How do I adjust the water temperature on my State Select Water Heater. I don't know where my manuel is and the water is too cool. Thank you.:)

State select water heater [ 2 Answers ]

How do I adjust the water temp?

View more questions Search