Ask Experts Questions for FREE Help !
Ask
    bbann's Avatar
    bbann Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 4, 2013, 02:05 PM
    Wall Thermostat Search
    I'm attempting to replace the thermostat in my hallway, inside it had a series of numbers & letters T99BV303J do I have to get this ATT product or would any other replace the unit.
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Aug 4, 2013, 02:40 PM
    Those numbers and letters describe connections. Tell me you didn't just remove the wires without noting what wires were connect to these letters and numbers.
    bbann's Avatar
    bbann Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Aug 5, 2013, 10:58 PM
    Didn't touch anything, tested the wiring no juice anymore, have to go down and flip the switch.
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #4

    Aug 6, 2013, 02:52 AM
    Okay, then write down the colors of the conductors that are connected to those letters or take an up close picture of the connections before removing any wiring.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Facebook Wall Search? [ 5 Answers ]

Can you search someone´s Facebook wall for comments by a specific "friend"?

How do I add wall thermostat 2 my wall heater valve,Dayton 3e290.No wires on valve [ 1 Answers ]

I have a gas wall heater and the only way to turn on and off is to open bottom of heater and turn the knob on the Dayton 3E290 valve. I want to be able to run a wall thermostat but there are no places to add the wires. What can I convert the valve to so it accepts the remote thermostate Thank you

Wiring thermostat from wall to thermostat [ 2 Answers ]

I have a white rodgers 1F86 -244 thermostat and I believed it is wired incorrectly. I turned on the airconditioning and it would not start. The heat works. There are two wires from wall. One is red, other is blue.how do I hook them up to thermostat panel

Taking thermostat off the wall [ 1 Answers ]

I have a magic stat thermostat that doesn't appear to have any obvious screws. It has a half cover that swings upwards to get at controls. I can jiggle the whole thing a little bit and it moves as a unit, doesn't appear to have a cover that I can remove to get at any inside screws. I need to...

In Search of an in-wall diverter (two shower heads) [ 5 Answers ]

Hi there everyone, I'm remodeling my bathroom, and I've run into a problem. I'm using a standard setup for the bath with a dual handle manifold which uses a stop on the tub spigot to divert flow to the shower head, but I've made a decision that has put me at a stopping point. I've plumbed...

View more questions Search