Ask Experts Questions for FREE Help !
Ask
    scoramg's Avatar
    scoramg Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 30, 2013, 09:36 AM
    1982 dodge ignition switch removal
    How do you remove bearing housing to get to ignition switch?
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
    		  
    #2

    Jul 30, 2013, 12:10 PM
    Perhaps it would help to know exactly which 1982 dodge you are talking about... as there was more than one.
    scoramg's Avatar
    scoramg Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jul 30, 2013, 08:12 PM
    Sorry- been a hectic around the house and I submitted this question on the way out the door. 1982 Dodge Ram P/U, W150 4x4 - no tilt
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dodge stratus Ignition Switch [ 1 Answers ]

I think my ignition switch does not operate correctly even though the vehicle starts and runs . I think it does not turn off correctly and there might be battery voltage on the wiring harness when there should not be any. I can figure out how the contacts work inside the switch to determine if this...

What supplies power to the ignition starter switch on a 1979 Dodge D100 [ 0 Answers ]

I replaced the old broken instrument cluster with compatible Auto Meter gauges. To do this I had to cut the original (for lack of a better term) power dispersement unit for the old gauges and wired them individually to the new gauges. When I tried to start the truck there was no power coming into...

85 dodge ignition switch burned [ 0 Answers ]

I have an 85 Dodge truck with a 360 in it the fusible link for the ignition switch melted I replaced it it melted again the ignition switch was hot as well so I replaced it. I noticed some of the wiring going to the ignition switch had melted put all new in The red wire and blue wire. Drove for a...

1982 dodge truck alternator problems [ 3 Answers ]

I have a 82 dodge d 150 with a 318 my truck was dying and was not charging so I changed the alternator and it worked until I turned on the headlights then it died I noticed that the belt was loose so I tried to tighten it and then it ran fine all day then that night I turned on the lights and it...

Dodge ram ignition switch [ 2 Answers ]

I have a 2004 dodge ram 2500, the ignition switch seems to be locked anyone have any answers for me - key will not budge.

View more questions Search