Ask Experts Questions for FREE Help !
Ask
    mrsuthern's Avatar
    mrsuthern Posts: 2, Reputation: 1
    New Member
     
    #1

    Jul 10, 2013, 04:04 PM
    Briggs & Stratton push mower
    Ok this thing is driving me nuts. I have replaced the nasty air filter, new diaphragm and gasket kit with fuel screen for the carb. The thing will run like a champ for about 35 to 40 secs. And then shut off. I double checked plug gap. Pulled plug after shut down to see if its getting soaked as the exhaust has some smoke from it. Nothing noticeable.

    I am at a loss at this point. HELP!!
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
     
    #2

    Jul 10, 2013, 04:52 PM
    Its got a fuel restriction someplace. Double check your work and make sure the fuel strainer in the tank doesn't have a lot of crud and everything downstream from it is clean and clear... particularly the needle valve.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #3

    Jul 10, 2013, 06:40 PM
    I agree, remove the bowl and actuate the float by raising it and lowering it. Fuel should dump when the bowl is down
    mrsuthern's Avatar
    mrsuthern Posts: 2, Reputation: 1
    New Member
     
    #4

    Jul 12, 2013, 06:55 PM
    Ok... Remember now this is a small push mower with a standard B&S motor, bulb primer type carb on it...

    ~Rechecked the gasket for the carb to the tank- good
    ~blew air (canned air, PC cleaner type) through all ports and screens to check for any possible blockages - none found, or if there was.. . it was unknowingly shot out.
    ~Looked through the fuel port into motor and found nothing out of the ordinary.
    ~ Carefully re installed everything and got the same. Run like a champ and then dead after a hot second.
    ~Another evening of fighting mosquitoes and no result for my efforts. It's starting to become a good candidate for a target at the firing range.

    PS thanks for any advise y'all give.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs & Stratton Brute push mower will not start. Does small fuel stabilizer unit I [ 1 Answers ]

It fires right up but only runs for a few seconds and acts like it is out of gas. Does the small unit in gas cap that holds fuel stabilizer have to be full. Would this cause it not to stay running?

Snapper riding mower with 10.5 hp briggs & stratton mower [ 1 Answers ]

What is the single wire on the throttle control plate for

Pull Cord won't pull on my Briggs and Stratton 650 Series push mower [ 5 Answers ]

Ok here goes... The pull cord is stuck. Its pulls out about 4 inches then the cord stops. Looking into the cord area ontop of mower, I notice a small white plastic piece getting caught in a notch built into the cord housing. Now... when I loosen the cord a little bit, I can slide a butter knife...

Briggs & Stratton 10 hp lawn mower engine? [ 1 Answers ]

Just wondering if the flywheel should be in contact with the starter at all times as it appears to be! It has eaten the flywheel gear off! Stupid nylon gear! Is there any after market alloy type replacement? Numbers off engine plate Model 28a707 Type 0113-01 Code 951103za


View more questions Search