4.5 Briggs and Stratton push mower has new primer bulb but still won't start without

wtrmallon Posts: 3, Reputation: 1

New Member

May 8, 2011, 10:06 AM

4.5 Briggs and Stratton push mower has new primer bulb but still won't start without

Additional priming, carb clean or gas

ballengerb1 Posts: 27,378, Reputation: 2280

Home Repair & Remodeling Expert

May 8, 2011, 02:04 PM

How many times are you pumping the bulb, many require 10X

Add your answer here.

Check out some similar questions!

Briggs and stratton mower won't start. [ 2 Answers ]

Hi,can anyone help me,my neighbors cox stockman 13hp ride on won't start. I've replaced the solinoid, charged the battery and checked all the wiring,it still won't start,not even a click when I turn the key, my neighbor said it did turn over once yesterday then nothing,dead.I have also checked the...

Pull Cord won't pull on my Briggs and Stratton 650 Series push mower [ 5 Answers ]

Ok here goes... The pull cord is stuck. Its pulls out about 4 inches then the cord stops. Looking into the cord area ontop of mower, I notice a small white plastic piece getting caught in a notch built into the cord housing. Now... when I loosen the cord a little bit, I can slide a butter knife...

Primer bulb for push mower [ 3 Answers ]

I have a push mower that only stays running when the primer bulb is pushed in. When I let go of the bulb, it quits running. Does this mean there is a hole in the primer bulb. When I hold the primer bulb in it runs like it would normally. Any suggestions?? :confused: