Ask Experts Questions for FREE Help !
Ask
    Mommeekins's Avatar
    Mommeekins Posts: 1, Reputation: 1
    New Member
     
    #1

    May 27, 2013, 05:04 PM
    Old electrical wiring
    I am in the process of selling my older home in the home inspection it was found with an open circuit because the wire on that outlet had not been upgrades fron the old 2 wire wiring that was originally in gth house, aside from totally replacing the wire is there anything I can do to fix the issue?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    May 27, 2013, 06:18 PM
    home inspection it was found with an open circuit
    Define open circuit. If you mean an outlet that doesn't work then someone will have to determine why the outlet doesn't work. Then take corrective action. That should not mean replacing wiring. Nothing says you have to "upgrade" from the old 2-wire (ungrounded) outlet to a 3-wire or prong (grounded) outlet.

    If you do, code requires you use a GFI outlet and mark it "ungrounded".
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #3

    May 27, 2013, 08:12 PM
    Going from 2 to 3 wires has nothing to do with an open circuit, the third wire is a ground. It means you have a broken or disconnected neutral or hot and no voltage can go through the circuit. I would pull the outlet and look for a broken or loose wire and also check the outlet feeding this one, assuming it is wired that way.
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
     
    #4

    May 28, 2013, 03:26 AM
    Allow me to guess... if you plug something into this receptacle it works, correct?
    If so, you are being told that the outlet is "ungrounded".
    The next question is, could this be a "two wire" system? This is typical of older homes although becoming more and more rare. If your house has old romex "without" a ground wire, it may be permitted to remain by the your state building code.
    You need a good Electrician to review your home wiring system and then advise you of the relevant codes for your area. Good luck.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can substandard electrical wiring installation at home produce electrical arching [ 6 Answers ]

Can substandard electrical wiring installation at home produce electrical arching? Then fire?

Electrical wiring [ 1 Answers ]

Is is possible to get a wiring diagram for a Harbor Breeze model 80209 bathroom exhaust fan. Want to know how to separate light and fan to operate from separate switches.

Electrical Wiring [ 1 Answers ]

I have a 2 story house with 2 electrical panels. The house was built in the 60s. I want to move the panel in the living room to the panel in the basement, an install with 200 amp service. How do I go about removing the panel in the living room to the one in the basement without doing a total...

Electrical Wiring [ 2 Answers ]

Hello, I am wiring my basement. I am by no means a professional but I generally figure things out and like to adhere to code and inspections. I am running a line of recepticals around a corner. My questing is, Do I have to drill holes in the 2X4's in the corner or can I bring the cable up...

Electrical wiring [ 1 Answers ]

How to wire a sub panel for the purpose of installing a new elctric range in a remodeled kitchen. The main panel is a 100 amp square d breaker box , as is the new sub panel box. Sincerely, bill rinaldi Scranton, pa.


View more questions Search