[Socalstarter]

After readjusting my timing belt on my 92 honda accord it started stalling. It runs smoth and no noice at all but after I run it at the freeway at high speed and I stop at a light or an stop it stalls it starts back up without problem. Did somebody have an issue like this and how can it be fixed??

[TxGreaseMonkey]

Socalstarter, did you properly set the tension on the timing belt? Have you check the timing with a timing light? If all of the above checks out, consider replacing the igniter and coil.

[Socalstarter]

Socalstarter, did you properly set the tension on the timing belt? Have you check the timing with a timing light? If all of the above checks out, consider replacing the igniter and coil.

I did tension it jut turning the flywheel three teeth to the left my coil and igniter are good I just check them and I think when the igniter or coil are bad then I should have problems to start my car which I can't say. My car starts at the first crank but I will check the time with the gun. Do you have or know any link where shows how to use the gun? Thank u txgreesemonkey

[Stratmando]

Honda had ignition switch problems around that time.

[Stratmando]

92 honda accord ignition switch problem - Google Search

[Socalstarter]

Honda had ignition switch problems around that time.

I know the ignition switch is not the problem as I said I have no problems at all to start my car it starts at the first crank so it has to be something else I just don't know what it could be. I checked the timing and it is okay any suggestions will be welcome a.d appreciated thanks

[TxGreaseMonkey]

Socalstarter, many Hondas will start and run for awhile with a bad igniter and coil and then suddenly stall. If a strobe light shows the timing is set "spot on," then I would replace the igniter and coil.

[Stratmando]

Socialstarter, I knew some one who had about a '91 Accord, It Started fine, but would stall in Traffic, It had done this for about a year, I tested at the back of the Ignition switch(opposite the side the key goes into), will have to remove bottom half of shroud to access.
On this model Accord, The Ignition, B+, Start, Acc can also be accessed above the fuse panel.