Check out some similar questions!
Ducane gas heater location of manual reset
[ 2 Answers ]
Ducane package unit with gas furnace. Led flashes 3 times which indicates pressure switch stuck closed or open. I unhooked tubing and blew air into it, seems to be working OK, also I disconnected wiring and re-attached. This is the honeywell switch mounted on left side wall of compartment. I...
Limit switch location
[ 0 Answers ]
Can't find limit switch location on norodyne furnace model fg6rc 080c -16b. Updraft gas furnace. The red led stays on solid, works with ac, bit won't run at all for heat. No reset buttons, I found 2 are poped out. I found 2 bad limit switches, L250-25f , laying by the furnace from last service...
Bryant furnace reset location
[ 2 Answers ]
The bryant furnace we have is blowing cold air and when we try to increase or decrease the temp it flashes "HC" with heat, cool, auto, mngmt to the right of the "HC" what could be wrong? The filter was replaced 2 weeks ago and is clean.
Bryant furnace - must press manual rollout reset for burner to ignite
[ 2 Answers ]
My Bryant 350MAV furnace is not working properly. While the blower is first running it flashes a code 12. Then the light goes on solid and the burner never ignites. If I hold the manual rollout reset button for 20 seconds the ignitor starts to glow and the burner ignites. What needs to be... View more questions Search
Add your answer here.
|