Ask Experts Questions for FREE Help !
Ask
    jenmartin's Avatar
    jenmartin Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 1, 2009, 08:25 PM
    Bryant furnace reset location
    The bryant furnace we have is blowing cold air and when we try to increase or decrease the temp it flashes "HC" with heat, cool, auto, mngmt to the right of the "HC" what could be wrong? The filter was replaced 2 weeks ago and is clean.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Dec 1, 2009, 08:56 PM

    Does your thermostat use batteries by chance?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Dec 1, 2009, 09:36 PM
    Exact brand and model number of Thermostat?

    Exact model number of furnace?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Location of reset on janitrol furnace [ 4 Answers ]

We are getting colder... please recommend places to look for a reset button on janitrol furnace. Any help would be appreciated.

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Bryant furnace - must press manual rollout reset for burner to ignite [ 2 Answers ]

My Bryant 350MAV furnace is not working properly. While the blower is first running it flashes a code 12. Then the light goes on solid and the burner never ignites. If I hold the manual rollout reset button for 20 seconds the ignitor starts to glow and the burner ignites. What needs to be...

Furnace won't light without a furnace switch reset [ 15 Answers ]

Hello I have a Tempstar/Keeprite furnace model HGF120NE-1, Serial number 8464124770. (the exterior of the furnace has Tempstar logo and interior of furnace has Keeprite logo.) This furnace has an intermittent pilot light system. At times, especially in the morning after allowing a...

Location of the flamer sensor in a Bryant Model 383K Furnace [ 3 Answers ]

Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...

View more questions Search