 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How to set thermostats on 1970's electric radiant heating system
We have a radiant ceiling and floor heating system circa 1970's and I need to know the best way to set the thermostats. We have a separate one for each room, and I need to know if it is better to set them all at the same temperature and let them run constantly or if I should be truning them all down during the day? My husband says that they wall need to stay warm or it will use more energy to heat them rooms in the evening so if we turn it down during the day, it will take more energy to run them at night. SInce our electric bill was $400 I am not sure he is doing in right.
|
||||
Check out some similar questions!
Hello, I have radiant floor heating with propane gas. We built our home in 2003. We have a through-the-wall gas water heater furnace. The problem is we have hot water, but no heat. I turned the thermostat off and back on and it clicks but nothing else. The unit does not click on except to heat...
We replaced what looked to be original thermostats for three zones of radiant ceiling heat in 2008. They were King Electric ESP230's which are for double pole, 240v, 22amp. Then about a year later they started to act up. King says it was algorithm issues and replaced them twice! Now two years later...
Greetings... new member here. I hope someone can help with this. MY SETUP: I have a hydronic radiant floor heating system. 3 zones; basement, 1st floor, 2nd floor. 1 pump per zone. Heat source is 50 gal Polaris water heater. Pex tubing is mounted under subfloor with aluminum plates,...
We have a radiant heat system installed 2 years ago as part of a remodel of our daylight rambler. The downstairs is heated by radiators, the upstairs by the in floor system. The tubing for the radiant system is clipped to the subfloor of the upstairs in the same interstitial space as the domestic...
When I start up 2 or more zones of my radiant heating I get a whoo whoo noise over and over. Any suggestions? I have already tried bleeding the air from the system. The system has a newer bladder system expansion tank. It doesn't happen with just one zone, only when a second is activated.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
