Ask Experts Questions for FREE Help !
Ask
    RWShields's Avatar
    RWShields Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 30, 2012, 09:08 PM
    Goodman GMP075-4 Furnace Heater Burners will not ignite
    I have a Goodman GMP075-4 Furnace Heater. When the thermostat is turned up, the heating element/ignitor glows red hot, but the burners will not ignite. I suppose there is some kind of safety device that determines if there is enough heat present before allowing the gas to flow to the burners. But I don't see any probe near the ignitor. Any ideas or suggestions?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Dec 31, 2012, 05:14 PM
    Make sure the gas valve is set to "on" & any manual valves in the gas piping system are turned on . Do you get any blinking light on the control board when the furnace fails to light? If so, how many blinks between pauses?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman gmp075-3 won't ignite? [ 0 Answers ]

I have a Goodman GMP075-3. Woke up this morning to 60 degree house. Thermostat set to 68. Clean filter, batteries in thermostat are good. Can turn FAN on and it runs, but cannot get heat to kick on. Red blinking light on board. Power to unit. Draft fan never kicks on, never see ignitor glow....

Burner tubes for goodman heater model # gmp075-3? [ 1 Answers ]

I am having a problem adjusting flame on 2 of the 3 burners it will not adjust to a tight cone and the excess flame keeps triping heat censers I took apart and wire brushed everything inside burners can they go bad they are 17 years old.

Goodman furnace GMP 075-3 Burners will not ignite [ 2 Answers ]

I have a Goodman GMP 075-3 furnace that will not ignite. I have checked the hose to the pressure switch, and all the limit switches. I have four of them and they all register good. I even tried jumping them out. The igniter comes on and glows, but when the gas valve is supposed to open it does...

Goodman heater gmp075-3 3-blinks on board [ 1 Answers ]

I have a goodman heater gmp075-3, the problem is it don't work. Cleaned vent replaced the pressure switch. Still nothing. The board blinks three time which supposidally means a clog somewhere?? Please help if you can. Tom

Goodman heater gmp075-3 3-blinks on board [ 1 Answers ]

I have a goodman heater, I have cleaned out the chiminey pipe, replaced the pressure switch and it still will not ignite, can anyone point me in the right direction to repair this? Tom

View more questions Search