 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman draft inducer
I replaced my old goodman inducer (# B40590-01) and was told it was replaced with (013m00002s). My question is my old motor had two prongs to connect the furnace wires to the motor. I now have those to wires with no way to connect them as the replacement motor has wires already connected to it,, Do these wires just stay off the motor ?HELP!! THANKS,
|
||||
|
||||
|
What color are the wires that led to the old inducer, and what color are the wires that come off the new motor? It really is as simple as cutting, stripping, and wire nutting the wires together or running the wires from the new motor to the location on the control board where the old wires were.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My HVAC contractor identified that the draft inducer motor had seized on my Goodman furnace (this after he just replaced the blower motor this past April). I researched the replacement part after he gave me a quote and I would like to avoid his supplier's markup on the replacement motor, and...
I have a 5 yr. old dunkirk xeb3 boiler. This year on starting I noticed a smell of burnt gas coming out from around the draft inducer housing. I checked housing and gasket, both seemed fine. Fan only runs for approx. 5 seconds before ignition, and shuts off right after flame stops. Could this be...
FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S
The draft inducer on my furnice is stuck or something, it makes a humming noise for an extended period before the heat kicks on. The blower, the heat ignition everything is fine. It also seems like it starts too frequently.
I have a Janitrol Furnace that will not start up. I pulled of the tube from the draft inducer to the pressure switch. I sucked on the tube and the furnace fired up. So I checked the voltage going to the draft inducer, it read only 6v ac. Where do I go from here?
View more questions Search
|
