Ask Experts Questions for FREE Help !
Ask
    Bowler's Avatar
    Bowler Posts: 133, Reputation: 2
    Junior Member
    		  
    #1

    Dec 2, 2012, 04:40 PM
    Whirlpool Washer remove back?
    I have a Whirlpool washer that I have a bad inlet valve, as water keeps on running into the washer, even when the cord is removed from the outlet. I have the replacement valve asembly but haven't quite figured out how to remove the back of the machine to get at the old valve. I found the 2 screws at the bottom of the back panel and removed them, but panel appears to have to slide uppwards to get the panel off. It won't go! DoI have to remove the top to get it to slide up and if so, how do I go about that? Model WTW5300SQ2
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Dec 3, 2012, 08:05 AM
    Here are some manuals: https://dl.dropbox.com/u/8010163/Whi...%20Washers.zip
    https://dl.dropbox.com/u/8010163/Und...c%20washer.pdf
    These should help you, but what I do is to look at it and take out the screws I see holding it together. You should just take a putty knife and slide the blade between the top and bottom parts on either side of front of machine. As you push in you will feel the springiness of the clips. Just push in on clips and lift top and you will see water valves attached to back.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search


Check out some similar questions!

How to remove back off series 80 Kenmore washer [ 0 Answers ]

How to remove control panel from series 80 washer Kenmore to access pressure switch

Remove back of kenmore 70 series washer [ 0 Answers ]

I can not get the back of my kenmore 70 series washing machine off. The agitator does not work and I want to remove/replace it.

Remove Inner Tub on Whirlpool Topload Washer [ 1 Answers ]

I am trying to remove the inner tub on my washer. There is a lot of dirt built-up on the outer tub so I want to clean it. I have gotten to the point where I have removed the Locking Nut, but it still won' budge. It moves about 1/4 inch then hits something solid that does not appear to want to...

Whirlpool Gold Catalyst Washer remove the top [ 1 Answers ]

How do you remove the top of a Whirlpool Gold Catalyst Washer? There is a hose that connect at the top that is leaking.

View more questions Search