Ask Experts Questions for FREE Help !
Ask
    Dextersgma's Avatar
    Dextersgma Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 5, 2012, 11:46 AM
    York Diamond 80 won't blow heat
    I have a York Diamond 80 unit. The gas ignites and stays lit but no heat is blowing through vents. The outside unit is working? Any Suggests?

Check out some similar questions!

York Diamond 80 heat blower cycles 20 seconds [ 9 Answers ]

Hi, I have a 1996 York Diamond 80 furnace. Everything starts up OK (thermostat fine, flue fan kicks on fine, then pilot orange glow, then click, then gas burners fire up, then main blower fan starts). This all happens in about a minute or so, but then the main fan only runs for 22 seconds, then it...

YORK DIAMOND 80 Not Staying Lit. = No Heat blowing. [ 8 Answers ]

Hey you I have a York Diamond 80 - I don't have furnace model no. but I do have the Johnson Control board's model no. G91G951ADB-1403 (part no 031-01234-000). The problem: When I try to run the furnace the combustion blower, glow coil, and the 5 ports (burners) function. However the burners...

York Diamond 80 won't ignite and heat [ 0 Answers ]

I have a York Diamond 80 Model P2MPD16N09601G. The blower comes on but no flames. I checked the igniter assembly and it wasn't heating up, so I replaced it since this has worked in the past. It still doesn't heat up and glow. I also steel wooled the flame sensor, since I had to do that once...

My York Diamond 80 furnace stopped blowing heat [ 1 Answers ]

Hello my furnace stop blowing hot air, and there is no flame. Flashing code 4 for limit switch. Does any one know where it is and how to test. Any help would be appreciated, Thank you.

York diamond 80 blower works but no heat [ 1 Answers ]

the blower turns on and blows cont. but the burners don't kick on the blinking red light on the box blinks 4 times = high linit switch on

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.