Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
YORK DIAMOND 80 Not Staying Lit. = No Heat blowing.
[ 8 Answers ]
Hey you I have a York Diamond 80 - I don't have furnace model no. but I do have the Johnson Control board's model no. G91G951ADB-1403 (part no 031-01234-000). The problem: When I try to run the furnace the combustion blower, glow coil, and the 5 ports (burners) function. However the burners...
York Diamond 80 blowing cold air.
[ 13 Answers ]
Hi All... Hopefully uou can help me out... I have a york diamond 80 gas furnace. It was working fine up until a few days ago.. It began to blow out cold air when the house clearly was not even close to "requested" temp. It turns on, starts the initial motor, the humidifer also kicks...
York Diamond 80 blowing cold air...
[ 0 Answers ]
Like the title says it's blowing cold air. However the small troubleshooting sticker on the inside of the lower panel gives a list of possible problems IF the LED is blinking. Mine is not blinking (or illuminated for that matter). Also the unit constantly runs and the only way to shut it off is by...
York furnace Diamond 80 blowing cold air
[ 3 Answers ]
Hello, Our Diamond 80 furnace blows cold air when thermostat is set on 69F. So far I have cleaned flame sensor, replaced control board, limit switch and air pressure switch. The flame is coming on and works fine (no codes either). The first floor still gets somewhat warm air but the warm air...
York Diamond 80 Furnace Blowing Cold Air
[ 4 Answers ]
York Diamond 80 Furnace Blowing Cold Air. About five years old. Red light is flashing four times. View more questions Search
|