 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
York Diamond 80 won't ignite and heat
I have a York Diamond 80 Model P2MPD16N09601G. The blower comes on but no flames. I checked the igniter assembly and it wasn't heating up, so I replaced it since this has worked in the past. It still doesn't heat up and glow. I also steel wooled the flame sensor, since I had to do that once before as well. I have also shup power off at circuit breaker for several seconds and restarted. Still, the blower will kick on like it wants to start, but no flames. Any suggestions?
|
||||
Check out some similar questions!
Hi, I have a 1996 York Diamond 80 furnace. Everything starts up OK (thermostat fine, flue fan kicks on fine, then pilot orange glow, then click, then gas burners fire up, then main blower fan starts). This all happens in about a minute or so, but then the main fan only runs for 22 seconds, then it...
Hey you I have a York Diamond 80 - I don't have furnace model no. but I do have the Johnson Control board's model no. G91G951ADB-1403 (part no 031-01234-000). The problem: When I try to run the furnace the combustion blower, glow coil, and the 5 ports (burners) function. However the burners...
Hi experts, I have a 14 years old York Diamond 80 furnace. Starting about 2 or 3 years ago, it blows heat for about 20 minutes and continue blowing room temperature air. Shut off the thermostat or any thing in the thermostat will not turn off furnace blower. When the furnace starts blowing cold...
Hello my furnace stop blowing hot air, and there is no flame. Flashing code 4 for limit switch. Does any one know where it is and how to test. Any help would be appreciated, Thank you.
the blower turns on and blows cont. but the burners don't kick on the blinking red light on the box blinks 4 times = high linit switch on
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
