Ask Experts Questions for FREE Help !
Ask
    robert peterson's Avatar
    robert peterson Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 13, 2012, 06:30 AM
    Kenmore 6651703 Answer for low temp causing malfunction?
    Kenmore 6651703 Ultra Dishwasher. Clean light flashing, diswasher malfunctioned. Sears serviceman tested water temp at 84 deg. Need specific reason from Kenmore trouble shooting as to cause of failure in writing.
    robert peterson's Avatar
    robert peterson Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Oct 13, 2012, 06:33 AM
    Kenmore dishwasher 6651703. Cause of malfunction due to low water temp into dishwasher?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #3

    Oct 14, 2012, 07:03 AM
    Look at these: https://dl.dropbox.com/u/8010163/Whi...ishwashers.zip
    It sounds like you have an open heater element, but test it, first, before just replacing it. Also, the incoming water temp could be too cool. The manuals above are mostly for Whirlpool, but if you look carefully you should see one close to yours and the wiring is usually identical.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hi Temp and Heat Dry lights flash on Kenmore dishwasher 587.1521 [ 0 Answers ]

This happens after running a load- it feels like the load stopped before completing

Sears kenmore refrigerator setting of temp. Dial [ 0 Answers ]

My fridge is a model 252.60802400. When we moved in it was already set at this temp. I cannot tell which part of the dial is the point at which you move to cold or colder. We have tried all different directions and it freezes everything or I end up cutting it off instead. The markings are not...

High temp scrub light flashing red on Kenmore ultrawash dishwasher [ 0 Answers ]

The dishwasher will not power up and if I go to start it, the high temp scrub light begins flashing red. If I touch any of the buttons again, then the quick rinse light will begin blinking red in unison with the high temp scrub light and it still will not power up. What is wrong?

Kenmore Dishwasher Hi Temp Scrub Flashes-Ends Cycle [ 1 Answers ]

Hi, I have a Kenmore Ultra Wash Dishwasher (665.15822000) that is about 8 years old. It has started running for about the first 10-15 minutes of its cycle and than going to 2 min remaining on the digital display and ends leaving the hi temp scrub light flashing. I reset it about a week ago using...

View more questions Search