Ask Experts Questions for FREE Help !
Ask
    baloo2012's Avatar
    baloo2012 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 3, 2012, 01:18 PM
    Washing Machine Water In - Water Out
    My frigidaire model GLWS1339CS1 Washer is filling up with water in the tub but is also running water out the drain hose at the same time. ( I know this because I removed the drain hose from the house outlet, after receiving a ridiculously large water bill, ran it over the top of the machine and am letting it run out into the garage to monitor it ) When it begins to agitate the water continues running out the drain hose, losing the water level in the clothes tub, or the machine begins to fill again . This does not occur all the time, but more often than not. Please help. Thank you so much!
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
    		  
    #2

    Oct 3, 2012, 02:39 PM
    Hi baloo and welcome, make sure the clear plastic tube going from the drum to the pressure switch is clear, blow through it and you should hear the switch work. The link below tell of the three main causes of your problem. Good luck
    Frigidaire Washer Overflowing - Model GLWS1339CS1 - Repair Parts - RepairClinic.com
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #3

    Oct 3, 2012, 05:37 PM
    Either a plugged water level tube, a disconnected tube or a bad water level switch.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #4

    Oct 4, 2012, 06:56 AM
    Look at these: https://dl.dropbox.com/u/8010163/Fri...%20Washers.zip
    If your drain hose is lower than the tub water will run out. There are also valves that can stick. Look at this: https://dl.dropbox.com/u/8010163/Und...c%20washer.pdf
    And: https://dl.dropbox.com/u/8010163/How...e%20Manual.pdf
    You may need to use a meter to check it out, or it could be just something stuck.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No Cold Water to washing machine--new machine still has same problem [ 6 Answers ]

My washing machine stopped filling with cold water when necessary. Because it was an old machine and sometimes didn't spin out, I replaced it. The new (used) machine also doesn't have cold water. The valve works just fine, but has a little drip. Unless I am incredibly unlucky and have two...

Kenmore washing machine series 80 water runs into tub but won't fill with water [ 0 Answers ]

Water just keeps running into tub nonstop and doesn't fill

No water to washing machine [ 1 Answers ]

When we try to run our Smeg washing machine we get an error message that there is no water supply. However, the pipes are all clear and the water is flowing (and the filters are clean). We were told that the circuit board needed replacing. Is there not just some way I could re-set the machine? ...

No water in washing machine! [ 2 Answers ]

Hi My washing machine was working fine, its Simpson Esprit 700, heavy duty. But from last 2 days it can't get any water from hose when I turn it on.I hear the motor is running and there is water on the tap and the hose is not clogged.For some reason the machine is unable to get water inside. Any...

View more questions Search