Ask Experts Questions for FREE Help !
Ask
    GEORGE505's Avatar
    GEORGE505 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Sep 26, 2012, 12:20 PM
    My a/c clutch cycles too much, why?
    My a/c clutch cycles too much, why?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Sep 26, 2012, 12:24 PM
    If it's a domestic vehicle, the Clutch Cycle Switch may be bad. Simply remove the old one, apply PAG oil to the threads of the new switch, and install. Wear safety googles.
    GEORGE505's Avatar
    GEORGE505 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Sep 26, 2012, 12:26 PM
    2007 dodge ram 3500 a/c will work 95% of time.
    When I am pulling trailer the a/c will sometimes warm up
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Sep 26, 2012, 12:32 PM
    It could be a bad Clutch Cycle Switch or there could be a problem with the Blend Door Actuator. It's common for the A/C system to ice up, if there's a problem with the clutch cycle switch--check it out.
    GEORGE505's Avatar
    GEORGE505 Posts: 3, Reputation: 1
    New Member
    		  
    #5

    Sep 26, 2012, 02:13 PM
    Quote Originally Posted by TxGreaseMonkey View Post
    It could be a bad Clutch Cycle Switch or there could be a problem with the Blend Door Actuator. It's common for the A/C system to ice up, if there's a problem with the clutch cycle switch--check it out.
    Thanks will look into that
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where to attach clutch cable to clutch assembly on PO17542ST [ 0 Answers ]

I have a Poulan PO17542ST tractor with a 42" mower deck. The blade clutch spring assembly has become unattached to the clutch assembly. I can't determine where the spring is supposed to attach. Can you tell me where to attach it? Does it attach to the hole in the shaft on the right idler pulley?

Heater cycles too short and cycles many times before heat actually goes on... [ 0 Answers ]

I have a 4 year old Goodman heater model GMS81155CNA that we just replaced the blower motor on, fortunately it was under warranty until April. Now it keeps trying to cycle 2 or 3 times before the burners actually go on, sometimes it will ignite on the first attempt other times it won't. Often we...

How to build pressure 2001 honda civic clutch slave and clutch master [ 1 Answers ]

I have replaced clutch slave and replace the clutch master kit... tried bleeding it but there is no pressure, How do I get pressure to build... also clutch pedal is stuck and won't retract.

!Cycles Cycles Cycles! [ 1 Answers ]

I go through endless cycles, I will be happy and energetic, then super irratable and grumpy, then I blow up and go completely nuts with rage, then a deep, dark deppression sets in, and then it all starts again!! This can happen over months or I can cycle in just a few days, sometimes it even...

View more questions Search