Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Circuits
[ 2 Answers ]
Suppose that the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. (a) Find the steady-state current in each resistor. R1=16.00 kΩ, R2=12.00 kΩ, and R3=2.00 kΩ. (b) find the charge on the capacitor. 9.00V, 10.0uC I found part (a) but I'm...
Outlets for GFI circuits - bath & kitchen
[ 3 Answers ]
Hi - 2 questions: 1. I'm adding whirlpool bathtub as part of a remodel job. I've got 2 20amp dedicated lines, 1 for the pump, 1 for the heater. Each of these has to be on a GFCI breaker in the main panel, do I just use a regular receptacle under the tub enclosure, or is there a special...
Sub panel circuits
[ 1 Answers ]
I Want to replace an existing unused 20 amp two phase electrical outlet with a sub-panel containing single phase 110 volt circuits with appropriate circuit breakers. My question is: How many separate circuits does the NEC allow in this type of sub-panel?
New bathroom circuits
[ 1 Answers ]
I am remodeling my 2nd floor bathroom and adding laundry (gas dryer). I replacing old circuits with 2 new circuits. One dedicated to washer/dryer and another for one outlet, 2 vanity lights, 1 general illumination light, and for the exhaust fan/shower light. Can I make one 12/3 run from my...
Number of circuits
[ 5 Answers ]
I’m in the process of remolding my basement, basically 2 20x20 rooms. My question is how many separate circuits do I need for the electrical. All I’m talking about is lights and general use outlets. Could all the lights and outlets be on one circuit, or should they be separated? By room or by... View more questions Search
|