Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can I Update My 100amp Panel To A 150 Amp Panel Using The Same Awg2 Al-Triple Wire
[ 1 Answers ]
Can I Update My 100amp Panel To A 150 Amp Panel Using The Same Awg2 Al-Triple Wire That's Coming Into My House From Meter? Or Will I Need To Update That Wire To A Larger Wire?
Panel spec.in use for moter drive use as remote panel
[ 0 Answers ]
I want a panel spec. wich will have MCCB with auxlary contact on terminal block so that building management can use for a distance 50 mtrs. Kindly sugest mccb 400 amps incoming and different rating of MCCB for other loads.
Nec code for stapling wires from box
[ 2 Answers ]
What is the code for stapling a wire after you staple from the electrical box
Electrical box hight
[ 1 Answers ]
I was wondering what the standard hight is to install an electrical outlet box. I installed the boxes 12" from the floor to the bottom of the box was wondering if that is OK.I should note this is in a basement. Thank You Rob
100Amp disconnect panel before 100Amp main pannel
[ 5 Answers ]
I would like to relocate my main 100Amp panel to the inside wall of my garage. Code saids the main panel must be on an outside wall. What I was thinking of doing Is install a New Main panel on the inside wall of the garage and put a 100Amp disconnect at the old panel location. I am aware of... View more questions Search
|