Ask Experts Questions for FREE Help !
Ask
    gath2's Avatar
    gath2 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 14, 2012, 08:22 AM
    HVAC Blower works in Auto, but not in the ON position
    I have a Lennox 80MGF3/4-100A-1 furnace. According to the stickers it was converted to a heatcraft ignition control board EGC-1 at some point. I just moved into the house and noticed that I can not kick on the blower manually. The Heat and A/C both work fine and it kicks on automatically when needed. However, I'd like to be able to set the fan to ON to circulate air without heating/cooling.

    I thought it might be a loose wire on the thermostat, but everything appeared connected. So I purchased a new thermostat thinking maybe that was the issue. That did not help. I'm assuming this has to be a wiring issue, but know nothing about HVAC. I took pictures of everything that I thought was relevant in case that helps. Does anyone have suggestions for what I can try or what would be the cause of this?

    Pics can be found here:
    Https://picasaweb.google.com/107022855886113072599/FurnaceBlower
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Mar 14, 2012, 11:47 AM
    Are you sure there's a green wire connected to G post on the tstat
    jdublon's Avatar
    jdublon Posts: 10, Reputation: 1
    New Member
     
    #3

    Mar 22, 2012, 05:32 PM
    It sound like you have a problem on thermostat a wiring from the furnace to the thermostat
    smartpp7's Avatar
    smartpp7 Posts: 1, Reputation: 1
    New Member
     
    #4

    Jul 2, 2012, 09:36 AM
    Please email me at [email protected] if anyone has a solution to this problem.

    Thank you!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Fan works in ON position but doesn't work in AUTO [ 1 Answers ]

I have a gas heater and a Hunter thermostat (Model #44300). With thermostat set to HEAT, fan on AUTO, the heater turns on at programmed low temperature and off at programmed high as expected. Fan doesn't come on at all. With thermostat set to HEAT, fan on ON, the heater turns on at programmed...

Have older model Heil HVAC the fan blower works on heat but not on cool . [ 1 Answers ]

We have tried everything .Cleaned the coils on the outside unit , changed the thermostat and still the inside fan does not blow on cool but it works perfectly fine on heat .We also tried fan only and that didn't work either .

Blower would not work on AUTO position just ON position [ 9 Answers ]

I have installed new rooftop unit- electrical heating & cooling- few weeks ago. When I run the cooling everything goes fine (blower and composer) but if I run the heating; heat element will fire up but the blower will not work unless I put the fan on ON position not AUTO position, so, please, I...

Blower fan not working in auto position [ 1 Answers ]

I have a Rheem forced air gas heater. The blower fan works fine in the on position, but when in auto, it never comes on when the heater lights up. Help!


View more questions Search