Ask Experts Questions for FREE Help !
Ask
    mowmanmike's Avatar
    mowmanmike Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 21, 2012, 07:50 PM
    When I turn on the pto the blades turn real slow or not at all
    I have a wright sentar zero tur 52". It runs but when I turn on the pto the blades turn slow or not at all.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jun 30, 2012, 08:46 PM
    Hi,
    Here is a link to the parts manual. If the belt is routed correctly, suggest the nest step is a clutch adjustment. There are three slotted holes in the housing and three nuts to adjust. Set the gap through the slots to 0.012"
    http://www.wrightmfg.com/index.cfm?f...FE525345D360C5
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Edger blades won't turn [ 1 Answers ]

I have a black and decker edger, when I plug it in and engage the start button the blade won't spin a first, but then it will spin real slow but not w/ enough power to do anything how do I fix it?

Slow turn braking. Pedal Vibrates and Truck does not slow [ 1 Answers ]

Hello. I have a 98 Ford Expedition. My ABS brake sometimes comes on... When going in a slow turn, my pedal sometimes shakes and does not brake. I usually have to pump the pedal to get it to brake. What is this? Thanks for your advice in advance.

Pto clutch wires cut, fuse blown, engine still doesn't turn over [ 2 Answers ]

I have a troy-bilt 14 hp ltx lawn tractor. While turning off the pto switch, noise followed, then mower shut off... discovered the black/white wire to pto clutch was severed and the plug pulled out... the 30 amp fuse was also blown at the ignition switch.. I spliced the wires and plugged back in...

Making blades turn [ 7 Answers ]

Help, 1st of all I have a ceiling fan w/light fixture. The pull chain broke off from the inside, I've replaced the switch. At first the light wouldn't come on either so I switched the black wires. The wire colors are 1 red, 2 blacks & a 1 greenThe light works again but all the ceiling fan does...

Sears rider blades won't turn [ 1 Answers ]

I replace the engine on a used Sears 42", 6 speed riding mower. My problem is that when I engage the blades the engine stalls. The belt, 1/2" wide seems to be in a bind in the engine pulley groove. It will turn the blades if I manually turn the engine in the reverse direction, but not going in...

View more questions Search