Ask Experts Questions for FREE Help !
Ask
    mojoechef's Avatar
    mojoechef Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 23, 2012, 05:56 PM
    Bryant 561cj030-d
    Unit trips breaker immediately when it comes on
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    May 23, 2012, 10:09 PM
    Quote Originally Posted by mojoechef View Post
    unit trips breaker immediately when it comes on
    Usually that means you have a dead short in the circuit OR the compressor itself is shorted if it is a condensing unit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 561CJ030-E [ 0 Answers ]

I have a Dual system for my house. One of them does not turn on, no fan movement. Circuit breakers are both ON. Where is the best place to start looking for the problem?

Bryant plus 90 [ 0 Answers ]

Fan blower works but no heat. Is it the ignitor or flame sensor?

Bryant ac unit model # 561CJ030-E [ 1 Answers ]

Went to turn on unit for the first time this year and it is not working. I cannot provide much more detial than that. I was reading and it says there is two breakers; one at the electrical panel which I checked and one behind the unit outside which leaves me puzzled. There is a plug that when I...

Bryant plus 90 [ 0 Answers ]

Code 31 . The ignitor is taken out for replacement. The inducer moder does not start in the beginning. It starts after the 90 second blower motor runtime. What might have gone bad?

Bryant [ 1 Answers ]

I have a bryant plus 80 series g furnace. Model 395CAV048111. My furnace will start a cycle but goes off. Then the led will flash 5 times, pause and then repeat the 5 flashes. Also, if I unplug the furnace it will reset and complete a cycyle, then it will start going off again. Any help would...

View more questions Search