 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have a bryant plus 80 series g furnace. Model 395CAV048111. My furnace will start a cycle but goes off. Then the led will flash 5 times, pause and then repeat the 5 flashes. Also, if I unplug the furnace it will reset and complete a cycyle, then it will start going off again. Any help would...
Hello. I have a Bryant plus 90 furnace. Approx 8 years old. It will run for about 5 minutes then stop before reaching desired temp. Then it will try to start up again but shut down before ignition. Flipping power on and off will make it work again. I cleaned the flame sensor with no change. It...
Bryant gas funace model 310aav042090aaja. Code 33. Wired around limit and it worked fine. Replaced with new limit throws code again. Vents clear. Filter clear. What next? Is it really getting too hot? Runs about 4 minutes before throwing code and cycles down about 3 minutes.
I have a Bryant Model 398A, Deluxe gas-fired condensing furnace, vintage 1987. The unit performs well but recently I noticed a raw propane smell outside my home which is coming from the furnace exterior discharge vent (3 in. PVC pipe). A repairman found and corrected a couple of minor gas leaks...
I have a 2007 Bryant Plus 90t Furnace and since it was installed 1n 2007 the Flame Sensor had to be cleaned 3 times, what's the problem why does the flam sensor get corroded and the furnace won't light.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
