Ask Experts Questions for FREE Help !
Ask
    friends7's Avatar
    friends7 Posts: 18, Reputation: -1
    New Member
     
    #1

    Apr 2, 2012, 07:21 AM
    MF 860 digger won't drive after transmission oil was over filled
    My MF digger will no longer drive after the transmission oil was over filled. The oil has been drained back to the corect levels but it still will not move. When I engage the forward lever the wheels move it the right direction but only just a jolt and the same when I put it in reverse. I had a problem with the forward reverse solonoid before and wanted to check if this was at fault. When I put it eithr into forward or reverse should I get a voltage of 12v across the spade connectors attached to the solenoid?
    Any help or thoughs would be much apprieciated.
    Thanks
    friends7
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Apr 2, 2012, 10:36 AM
    Check all fuses with a test light or multimeter. Clean all connectors with abrasive cloth.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Engine filled with coolant and is mixed with oil [ 11 Answers ]

I was wondering why my temperature gauge was going up so high, although the engine didn't actually get too hot. I couldn't understand why the coolant wouldn't remain in the radiator and I filled it up several times. I Checked the oil a couple days ago and the dipstick was covered about 7 or 8...

My oil furnace is blowing cold air and the tank should be filled up -how do I check I [ 0 Answers ]

My oil furnace is ten years old and I replaced a thermostat two years ago and this past September I replaced the ignition transformer . I live in Canada with our wonderful four seasons but at times our Winter's can be cold. What is the most efficient type of heating and easiest to use for someone...

MTD, 5HP B&S oil over-filled, will not crank [ 3 Answers ]

I have an MTD lawnmower with a 5 hp B&S engine with primer. The oil was over-filled. I drained the oil/refilled and changed the spark plug. Now, I have to put starter fluid in the carb to get it to crank. However, it will crank but quickly die. It will not crank without the starter fluid. What...

Distributor filled with oil - 1989 accord DX? [ 1 Answers ]

I just had my 89 accord dx (carb) auto trans 132k miles tuned up. It cost me 300.00 for a full tune up and oil change. They told me my distributor needs to be replaced because it was leaking past the “O” ring and had filled the distributor with oil. I asked about replacing the “O” ring and they...


View more questions Search