Ask Experts Questions for FREE Help !
Ask
    johnstoirvin's Avatar
    johnstoirvin Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 26, 2010, 01:09 PM
    Goodman GMP100-4, no blower fan
    Light on solid, ventor on, ignition, no fan, flame goes out after 30 sec, ignitor heats up, no ignition, no fan, recycles. Fan works w/fan sw. on stat. Cleaned flame sensor. Same result. Will sometimes work continuously w/fan switch to on and stat in heat mode.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Oct 26, 2010, 04:25 PM

    SOunds like a bad fan relay. But if that was the case it should work with the fan running all the time. Inless the heat exchange is cracked
    johnstoirvin's Avatar
    johnstoirvin Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Oct 27, 2010, 09:55 AM
    Comment on Joshdta's post
    Relay runs fan w/fan sw to "on". CO2 detector shows no gases from cracked exchanger. If I put fan sw to "on", then unit runs fine, but continuously. Will not stay lit in fan "auto".
    acortez80015's Avatar
    acortez80015 Posts: 1, Reputation: 1
    New Member
    		  
    #4

    Feb 17, 2012, 06:47 AM
    The furnace is going off on high limit, I would start by taking a apm draw on motor while it runs with t state in on posistion if normal (2-3.5 amps) try the same test with t stat in auto, if reading is around 6-12+ amps replace motor and capaciter. If no reading check for power on control bored at the heat terminal upper right hand corner, if 120v is not read while burners are light and t stat is in the auto setting I would replace control bored
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman gmp100-5 furnace fan stays on [ 1 Answers ]

My Goodman furnace fan stays on... even with the thermostat disconnected. The red status light stays illuminated the whole time. Do I need a new control board maybe? Any help appreciated. Thanks...

I have Goodman GMP100 furnace. The vent blower won't run [ 1 Answers ]

On the Goodman GMP100 furnace, the vent blower tries to run but stops immediately. The status light blinks 3 times. Is there a way to find out if the vent pressure switch is defective?

Goodman GMP100-4 [ 1 Answers ]

The light is continuously blinking and trying to figure out source of problem or what I need to replace. AAA appliance came over it was coming on for a few seconds and now it's not working at all any suggestions what they might have done.

Goodman GMP100-3 [ 1 Answers ]

Hi, Have a Goodman GMP100-3 that's acting strangely. Here's the scenario: - Thermostat calls for heat - Inducer starts - Vacuum switch pulls in - Furnace fires - Furnace comes up to heat and blower starts - Ignition cuts out as blower starts

Wiring inline duct fan to furnace fan goodman gmp100-4 [ 2 Answers ]

How do I wire my inline duct fan to my Goodman model gmp100-4 gas furnace fan so that the inline duct fan comes on and off when the furnace fan does? I understand that I need a relay from the inline duct fan but don't know where to connect the relay to the furnace.

View more questions Search