Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Br220 breaker: 208/230 welder
[ 5 Answers ]
At the service panel, I have a Cuttler Hammer BR220. The assigned receptacle is a twist-loc 250V 20A type (NEMA LS 20-R). The welder I want to use is a Tri-Arc 160 which is rated for 208/230. This plug does not match the wall receptacle. What is the path of least resistance to turn...
Wiring a welder
[ 3 Answers ]
I have a quick question about hooking up a welder. Lincoln 225/125 AC DC with a 3-prong plug. I am using 8-3wire, can I use the white wire as my ground in the panel and can I also use the bare wire connected to an anchor screw in the plug to the same ground connection in my panel? Thanks, Dale
115v arc welder tripping 20amp breaker
[ 2 Answers ]
I just bought a Arc Welder that can use 220 or 115 but since the only 220v outlet is the dryer inside the house I had to choose the 115v mode. I have it plugged in inside the garage on a 20 amp breaker. The manual said no to go above 70v on a 30 amp breaker. The job I need requires all 70v and when...
Welder
[ 1 Answers ]
I found an old lincoln welder that I can't identify. I guess it looks like a water tank about 4 feet tall and 3 feet wide with a crank on the side. Ring any bells View more questions Search
|