Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can I replace a slip on tub spout with no diverter to a tub spout with a diverter?
[ 1 Answers ]
I have a slip on tub spout that has no diverter. I would like to exchange this tub spout with one that has a diverter.
Replace tub spout by shower
[ 3 Answers ]
I would like to install a hand held shower instead of a tub spout in my new shower. Using a shower kit that has the diverter on the wall-mounted shower lever hand panel (as opposed to a pull-up diverter on the tub spout) I hope to run a hand-held shower from the valve output that would have...
Remove and Replace Tub Spout
[ 9 Answers ]
I have an Alsons tub spout with diverter. It has 2 little holes at the bottom, one on each side. Since it doesn't have just one hole and allen screw, I am assuming I can unscrew it. It will only move 1/4 turn! The diverter knob doesn't pull up at this point and won't move until I turn the spout...
How to replace an old tub spout to add shower
[ 2 Answers ]
I have an old tub/tub spout that I would like to add a tub spout with a diverter so that I can add a handheld shower. The spout has a front end connections. Do they sell a kit that has a shower (not handheld) but connects to spout that will fit my connections? I did see one for a rear connector?...
Trying to replace Weird Size Tub Spout Diverter
[ 3 Answers ]
When I pull up my Diverter for my shower, It sprays a lot and cuts down on my shower's stream. So I decided to replace it yesterday. I determined that it is the screw on type and removed it. But when I took it off I noticed that there was a 1/2 inch copper pipe with a 1 1/4 inch thread attached... View more questions Search
|