Ask Experts Questions for FREE Help !
Ask
    dscott0111's Avatar
    dscott0111 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 14, 2011, 03:34 PM
    Inducer motors
    Can you give me the average price for an inducer motor for a luxaire heating/cooling unit?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Dec 14, 2011, 03:39 PM
    Just the motor can run over $200. Removal of the old motor and install of the new one can be done by most DIYers American HVAC Parts 1/15 H.P. 460 Volts RPM 3000 Rotation C.C.W.(FASCO, YORK) The one shown may not be your exact model, they vary with model and I don't see that you gave us that part
    dscott0111's Avatar
    dscott0111 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 14, 2011, 04:19 PM
    Thanks so much this was helpful. I have been given an repair estimate of 422.00 and this is very hard to pay out right now. I wish I could do the work myself. Is it an easy repair for homeowners?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #4

    Dec 14, 2011, 06:32 PM
    Yes if you are handy with tools.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Comparison between single phase motors & three phase motors [ 3 Answers ]

Why single phase motors draws more current than three phase motors

Inducer motors for York Diamond furnaces [ 1 Answers ]

I have a York Diamond 80 which when it starts up the seems to be a vibration that can be heard on the main floor(furnace is in the basement). Upon start up I can grab hold of the inducer motor and the noise goes away. Should I be concerned enough to go out and buy a motor and fan blade to have...

The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman. [ 8 Answers ]

FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S

3 phase motors and single phase motors [ 4 Answers ]

Mike holt stated on one of his classes that in order for any eletrical equipment to work, that on one end had to be voltage and on the other side it had to have no voltage. So when the voltage goes to a three phase motor where does it go? Does it go to ground? I understand that the 3 phases are 120...

Goodman inducer motors [ 3 Answers ]

Any service guys out there. I can't fiqure this one out. I just installed this 90plus furnace last yr barley used in a guest house in n.c. system ran fine never turned on just when needed for winter in the basement cause the temp in charlotte nc is warm mosly around the whole yr. went to turn...

View more questions Search