Ask Experts Questions for FREE Help !
Ask
    jtjb4's Avatar
    jtjb4 Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Dec 11, 2011, 04:00 PM
    Bryant plus 80 Furnace Won't Stay on?
    I keep having to stroke the power on my furnace to get it to come on. It does not always light on first try. Sometimes I have to do this several times. I have replaced the filters. I have clean the flame sensor with sand paper. I have cleaned the furnace. It will run fine for 2-4 cycles then right back where I started.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Dec 11, 2011, 07:49 PM
    Is the code on the control board-- flame proving failure? If you count the blinks on the control board it will give you the reason for lock out
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 350mav furnace won't stay lit runs 30 seconds and turns off [ 0 Answers ]

Bryant Plus 90 won't stay running [ 0 Answers ]

I have a Bryant Plus 90, model 398AAW036080. Year on rating plate is 1982, but I know it was installed a few years after that since I've only lived here since 1984. I had to have the gas valve replaced in June of 1998. I suspect it is bad again, as here are the unusual symptoms, which lead me...

Bryant Furnace will not stay on [ 1 Answers ]

Our Bryant Furnace thermostat click on, the furnace fires up, and in less than a minute... it shuts off again. What's the problem?

Bryant furnace flame won't stay lit after a few minutes [ 8 Answers ]

I have a Bryant Plus 80 model 395C that is 17 years old. I turned the furnace on this weekend and it starts up just fine. The draft blower starts, the igniter glows, the valve opens and it lights the burners. After it heats up the blower comes on as always. After about 3-5 minutes the burner goes...

Bryant-burners won't stay on. [ 1 Answers ]

I have a Bryant Model 397H. Have had an intermitent problem for the past 3 years. Furnace starts normally, burners come on and in about 5 seconds go off. This can repeat two to three times before remaining on and running normally. I have had two repairmen out to look at it and both times it would...

View more questions Search