Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Gas furnace flame cycling every 15 seconds after 10 min running
[ 0 Answers ]
My Goodman gas furnace comes on and heats to about 145 degrees at high limit switch after running 5-10 minutes and then cuts the flame off and on every 10-15 seconds. The furnace runs like that until thermostat cuts it off. I jumped out high limit switch and roll out switch and couldn't change...
Bryant Plus-80 gas furnace -- How can I increase the frequency of cycling?
[ 1 Answers ]
-- currently the temperature swings are more than 5 degrees
My ruud gas furnace is not cycling properly
[ 0 Answers ]
During day seems fine at night won't maintain temp over @62 deg F
Comfortmaker RPJ II (2) gas furnace short cycling during idle
[ 13 Answers ]
I have a Comfortmaker RPJ II (Enviro plus 90) gas furnace connected to a programmable thermostat that works and cycles on and off fine when inside temp is lower than set target temp - exhaust blower cuts on, pressure switch engages, igniter glows, valve opens, pilot lights, valve opens, jets...
Older gas furnace is short cycling
[ 32 Answers ]
I have an older Sears "Fifteen" horizontal gas furnace (#867767840) located in the crawl space. Recently it has been short cycling, meaning it starts a normal cycle, runs for approximately 1 minute, stops for several minutes, then starts another 1 minute cycle. This repeats until the set... View more questions Search
|