My ruud gas furnace is not cycling properly

Check out some similar questions!

Electric Furnace 20 - Fan not cycling properly [ 8 Answers ]

Hi I have a 20KW Lincoln ( similar to Broan) Electric Hot Air furnace. It is less than a year old and was working fine until today when the fan would not Come on when the thermostat would request heat. The furnace has a fan switch with gives the choice of fan on/off. When the switch...

Comfortmaker RPJ II (2) gas furnace short cycling during idle [ 13 Answers ]

I have a Comfortmaker RPJ II (Enviro plus 90) gas furnace connected to a programmable thermostat that works and cycles on and off fine when inside temp is lower than set target temp - exhaust blower cuts on, pressure switch engages, igniter glows, valve opens, pilot lights, valve opens, jets...

Armstrong-Air Gas Fired Furnace G1D91AU NOT heating properly! [ 6 Answers ]

I have an Armstrong-Air Gas-Fired furnace G1D91AU and maybe a programmable thermostat. The system is around six years old and it has started causing me problems this winter. The system has been inconsistent when following the preprogrammed settings. It will NOT warm above 70 degrees no matter...

Older gas furnace is short cycling [ 32 Answers ]

I have an older Sears "Fifteen" horizontal gas furnace (#867767840) located in the crawl space. Recently it has been short cycling, meaning it starts a normal cycle, runs for approximately 1 minute, stops for several minutes, then starts another 1 minute cycle. This repeats until the set...

Not cycling properly [ 2 Answers ]

My fan and gas shuts off after only a few minutes in the heating cycle and restarts again shortly, only to shut off again... and so on. I think it's the fan limit switch but don't know if I should replace it or try adjusting the limit. Any advice??

View more questions Search

Check out some similar questions!

Add your answer here.