Bryant Plus-80 gas furnace -- How can I increase the frequency of cycling?

DennisV Posts: 1, Reputation: 1

New Member

Oct 28, 2010, 10:19 AM

Bryant Plus-80 gas furnace -- How can I increase the frequency of cycling?

-- currently the temperature swings are more than 5 degrees

Joshdta Posts: 2,549, Reputation: 45

Ultra Member

Oct 28, 2010, 05:25 PM

Sounds like it may be time for a new t-stat, or your unit may be going out on limit. Ever felt cool air blowing?

Add your answer here.

Check out some similar questions!

Bryant furnace cycling on and off [ 6 Answers ]

I have a Bryant gas furnace, model# 310AAV048135. It comes on, runs for a couple minutes then shuts off while the blower still runs. I am getting a fault code of 33, which indicates several things according to the label on the device. Earlier in the summer, I was having a similar problem when...

Bryant furnace short cycling [ 4 Answers ]

I have a Bryant 80 furnace , had the ignitor replaced in November. Since then the furnace will power up, ignitor and burners will go and then when the blower turns on the burners go out, the blower will go for about 90 seconds and then shut down. It will do this repeatedly sometimes as many as 30...

Furnace short cycling Bryant Series SB C Model 100 393J [ 0 Answers ]

My furnace has been short cycling. Bryant upflow forced air furnace Series SB C Model 100 393J It will run for approximately 10 to 15 seconds, shut off for approximately 1 minute, run for 10 to 15 seconds, shut off for approximately 1 minute. It does this for around 7 to 9 times then...

Bryant furnace cycling on and off [ 6 Answers ]

Thanks for taking your time to read this post! I have a Bryant natural gas furnace model 383KAV036070 that is about 7 years old. It started working sporadically about a week ago. I replaced the thermostat with no luck. It seems that it is reading a trouble code of 34. It will start up and ignite...

Bryant furnace keeps cycling on [ 2 Answers ]

I have a Bryant Legacy plus 90 furnace that is about 2 & 1/2 years old. The furnace will kick on and run till the temp on the thermostat is reached, it then shuts down but will immediately start back up again and continue to cycle like this 5 or 6 times until I adjust the thermostat down a degree...