Ask Experts Questions for FREE Help !
Ask
    RDJackson's Avatar
    RDJackson Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 5, 2011, 12:08 PM
    Wall panel not lighting up
    My wall panel that I change settings on is a complete blank. I don't see a battery and I've checked so see if circuit breaker was tripped but it was not. Any idea what the problem might be.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Oct 5, 2011, 05:00 PM
    Need to find out for sure if your stat requires batterys. Maybe contact the manufacturer of the stat. Other than that, it could be a bad stat, bad stat wire, or power problems at the furnace. Need to get your multimeter out and start checking for power to furnace, to control board, to transformer, out of transformer, etc. If you are handy with a multimeter, we can try to take this one step at a time.
    RDJackson's Avatar
    RDJackson Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 9, 2011, 08:37 AM
    The float switch had been moved in the furnace pan and turned off the system. It was an easy fix for the repair man. Thanks
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #4

    Oct 9, 2011, 05:35 PM
    Thanks for the update, we always appreciate that. Take care.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

NEC question: Dose a lighting panel require a main breaker? [ 1 Answers ]

Replacing 5 panels in a High Schoo (120/208v panels). All branch circuits feed lighting and receptacle loads. They are very old and also "main lug only". Do I have to have a main breaker in the new replacement panels? If so where is this in the code? Mike

What gauge wire is good for can lighting, track and wall sconces? [ 9 Answers ]

Just wanted to know if 12 gauge or 14 is good for all the lighting that I will install in a home. I know that according to code 12/2 is needed for gfci, bathroom, and kithchen use. What about lighting in a residential home?

Damp on bedroom wall after lighting a fire downstairs [ 2 Answers ]

At the weekend we lit our log burning stove downstairs for the first time since late spring. A damp patch appeared on the bedroom wall above the room, just above the skirting board and about in line where the chimney is, what could this damp be? It has dried out but has left a satin on the wall...

Lighting Empire wall furnace pilot light [ 1 Answers ]

:o, Please help! I have accessed the inside of my Empire wall furnace & understand the instructions on the knob relating to startingg the pilot light. Have lit pilots of water heaters many times. My question simply is: Where is the place to place the match to get ignition? It refers...

Lighting a wall gas heater [ 2 Answers ]

How do I light a gas wall heater

View more questions Search