Ask Experts Questions for FREE Help !
Ask
    froehlri's Avatar
    froehlri Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 19, 2011, 07:28 AM
    Craftsman 18.5 OHV only idles with very low RPM
    My Craftsman 18.5 ohv mower will start with the choke on. It will only run at a very low idle (with the choke on fully) for a short time then die. If I try to take the choke off it dies right away.

Check out some similar questions!

Idles too high and rpm climbs between shifts [ 1 Answers ]

2000 Pontiac Grand AM 2.4 ltr standard trans normal idle is 8-900 rpm. Engine check light came on no code showing . Started up and rpm jumped to 2000RPM throttle closed and when on highway RPM increases when clutch depressed to shift. Rpm will not decrease when you lift gas pedal. When you drop it...

1998 honda accord idles rough and when I give it gas above 2000 rpm it drops [ 2 Answers ]

I just changed the throttle body gasket on a 1998 honda accord now when I turned the car back on it idles rough and when I give it gas above 2000 rpm it drops back to 1000.

Craftsman Lawn Tractor Idles But Won't Run or Mow [ 3 Answers ]

Craftsman Lawn Tractor stalls when clutch/brake released whether in gear or neutral. However, will continue running if park brake set and left in neutral. Also stalls if I attempt to engage deck. Could this be anything other than seat switch? Please help... won't be able to find tractor if grass...

Craftsman 16.5 OHV won't stay running [ 3 Answers ]

I have a craftsman 16.5 IC OHV that I just replaced the fuel cylenoid switch on because it wouldn't crank without pouring gas into carburetor. Once I changed that, it ran for about 10 minutes then shut off. I was able to jump it off with jumper cables a couple of times, and it kept shutting off. ...

99 niss altima runs rough and idles low when ac is on [ 5 Answers ]

I have a 99 nissan altima that has roughly 98000 miles on it. I bought it from a used car dealer, and noticed the check engine light was on and ran a little rough. Took to auto parts place and they checked the code and said cylider 2 was misfiring. So I changed the plugs, wires and cap and still...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.