 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Installed new Honeywell thermostat...
Installed new Honeywell thermostat and the display reads, but when we try and tun on the air or the fan, nothing comes on. Checked all the 5 wires (red, yellow, white, blue and green) and they seem to be screwed in tight. Checked the circuit breaker and it is OK, also. Is there anything on the outside unit that needs to be reset? Any ideas would be appreicated
|
||||
Check out some similar questions!
I have an all electric unit with a hot water traditional tank. The wires coming from the wall connected to the old thermostat as follows: Red to R Blue to C Yellow to YY2 Green to G White to W The Honeywell customer care rep told me not to use the blue wire. He instructed me to connect...
And now my heater just stays on. I followed the wiring from the old thermostat exactly. There were four wires, but only the red wire was connected to RC and the yellow was connected to W. The black and green wire were not connected to anything. Any suggestions?
I have installed a Honeywell rth7400 thermostat on my York Heat Pump. The normal heating and cooling cycles work fine, but in the "emer heat" mode, the circulating fan in the inside unit runs all the time. I have verified that the resistor elements cycle as they should and the house temp is held...
I recently installed a honeywell rth7500 thermostat and am not sure if it is correct. The old thermostat is a GE, not sure how old. I have a heatpump system (Goodman A61-20) I wired it as follows: Old R(red)- new R Old O(orange) - new O/B Old G(green) - new G Old Y(yellow) - new Y Old...
I have tried to comb through the threads to find a problem that fits mine, but I didn't find it. So please forgive me if this is a repeat question for something that has already been presented. I have just installed 2 Honeywell programmable thermostats (RTH7000 series). The one for my...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
