Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacement condenser fan motor wires are too short - now what?
[ 2 Answers ]
The wires are about 10 inches too short. In normal wiring one would make a junction box and wire up extensions, but there is no place for a junction box inside the unit, of course. The original fan motor also used a flexible metal conduit, although the new fan wires appear to be overinsulated for...
Old AC condenser fan motor - which wires are which?
[ 5 Answers ]
I have a Climatrol unit with an Emerson condenser motor that is shot. I bought an Emerson Rescue motor to replace it from the local AC supply store. The wiring diagram was stored in the AC unit, and it is no longer readable. The three disconnected motor wires from the old unit are yellow,...
Emerson motor condenser wiring replacing 3 wire motor with 5 wire.
[ 5 Answers ]
Any recommendations? New motor apparently is capable of running in either direction by switching brown and purple wires going to the capacitor. Looks like then either the remaining brown or purple is spliced to or hooked up to the same terminal as the yellow. Thanks.
Emerson condenser fan motor
[ 5 Answers ]
I just replaced my condenser fan motor old one is a Emerson k55hxlrh-0208 1/5 hp 1.0 amps 208/220/240 volt 850rpm .The closes one I could get is 1/5 hp 208/230 volts 1.3 amps 1075 rpm now is shuts off in the miday heat
Can any 4-wire condenser fan motor be wired with 3 wires
[ 0 Answers ]
I had someone ask me today how to replace a 3-wire condenser fan motor with a 4-wire motor. He said there was not a 3-wire connection diagram on the motor. I told him to just use a new capacitor and wire it with all 4 wires. But my question is; Can any 4-wire motor be wired with the 3-wire... View more questions Search
|