Ask Experts Questions for FREE Help !
Ask
    jrod1's Avatar
    jrod1 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 23, 2011, 05:29 AM
    92 camry 4cyl 2.2 won't start, everything else works perfect, is it ignition switch?
    92 camry will not start when key is turned. Everything else works fine. I bypassed ignition wire to starter, and connected lead on starter direct to battery lead, and it started like it should. Does this mean my ignition switch is bad? Anyone got another possible diagnosis? Ohh sorry I forgot to mention my camry is an automatic, and after I bypassed that little wire to the big wire on the starter the car runs great until I turn it off. Then will only start by repeating procedure. Any response is greatly appreciated, thank you for your time
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Apr 23, 2011, 06:23 AM

    The problem is with the ignition switch, neutral start switch, or wiring. Check the ignition switch for wear, pitting, or melting. Odds are high that the problem is with the ignition switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bypass ignition switch to start [ 3 Answers ]

How can you hot-wire or bypass ignition switch to start a MTD transmatic lawn tractor models 760-779

1996 camry LE 4dr sedan 4cyl cranks but won't start? [ 3 Answers ]

Yesterday my camry was running fine. After the engine was off for about 4 hours, I tried to start it and nothing happened -- no cranking, no clicking noise, no bells, no dash lights. I jumped the battery (battery's about 2 years old) and still no cranking. I looked at the fuse blocks near the...

97 Toyota Camry 4cyl. While driving it Died! [ 7 Answers ]

97 Toyota Camry 4cyl. While driving it Died! While driving it stalled and came to a stop. It was spurting like it was going to run out of gas (before it died) but the tank is 3/4 full. While trying to start it up again it sounds like the starter is just spinning. All the Belts turn while trying...

Why won't my craftsman, 18 hp Briggs rider start using ignition switch? [ 3 Answers ]

Key switch will not engage the starter, however it will work by shorting the posts on the starter relay switch. I have replaced the key switch,starter relay/solenoid, clutch/brake and blade engagement safety switches Did not replace the seat safety switch since the engine when running will shut...

Remote Start only works when key is in ignition [ 1 Answers ]

I have a Chevy Venture van and my remote start always worked great but now it will only work if I have the key in the ignition. Someone PLEASE help me :)

View more questions Search