 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman Furnace End switch closed without inducer on
I have a Goodman furnace, Model Number PGB036050-1 REV A.
LED is blinking 3 times, which, according to diagram on furnace " END SWITCH CLOSED WITHOUT INDUCER ON" I loosened the nuts on the Fan, Then if I give the back of the fan a little smack, it turns on and the furnace starts up. It will only run to the next cycle. The HVAC tech, said he probably can't get parts. Not sure if he is just trying to sell me a new furnace. What part can I replace or clean to keep this thing running? I would at least like to order the part then have a qualified person installl it. Thanks |
||||
Check out some similar questions!
Centrifugal switch closed (Furnace)?
[ 1 Answers ]
Centrifugal Switch Closed This is what my Coleman Evcon Furnace is telling me what do I need to do
Pressure switch open with inducer on- gas furnace
[ 2 Answers ]
Brand new ducane gas furnace has this error any suggestions?
Goodman venter end switch problem: 3 Flashing LEDs
[ 0 Answers ]
I have a Goodman PGB030050-1 and the status light is flashing 3 LEDs, which corresponds to the code "END SWITCH CLOSED WITHOUT INDUCER ON". When I reset the breaker on the end switch, everything fires up and runs fine for a few hours, then shuts down with the same status light code. I have read...
The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman.
[ 8 Answers ]
FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
