Check out some similar questions!
Trane XB80 gas furnace, no burners, four flashing leds, won't reset
[ 2 Answers ]
I have a Trane XB80 gas furnace and the fan works but the burners don't even try to come on. I had a similar problem last year and the tech came out and found an improperly installed filter that was clogged. After removing the filter, he restarted the furnace. It worked for a couple of days, then...
Small panell with 3 LEDS and stop switch and bell
[ 2 Answers ]
I have a small panel with 3 LED lights a stop switch and a bell. I have the same panel 15 meters away . What type of wire can I use not in pipe.
The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman.
[ 8 Answers ]
FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S
Goodman Furnace Venter
[ 2 Answers ]
I have Goodman Furnace model GMT 090- 3 installed in 1999 and it has stop working and when I open the cover of furnace I can see there is a red LED light that blinks three times and stops after a second or so it again blinks three times and stops this cycle is keep going, and furnace doesn't start....
Goodman gas funace pressure switch problem
[ 9 Answers ]
I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short time ( less than 30 seconds). The led on the circuit board gives me 3 flashes indicating " pressure... View more questions Search
Add your answer here.
|