Ask Experts Questions for FREE Help !
Ask
    FloridaMark2011's Avatar
    FloridaMark2011 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 20, 2011, 12:25 PM
    Can I install a light on my ac circuit?
    Can a outdoor light fxture be powered from an air conditioning disconnect box? It is straight A/C no heat.
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Feb 20, 2011, 12:59 PM

    First, what type of A/C unit is it?

    You know, window or whole house

    Is it a 120/240 unit?

    The short answer is "No". A/C units are typically installed on dedicated circuits.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #3

    Feb 20, 2011, 01:04 PM

    Assuming a 240V A/C, no. There is no neutral at the disconnect box.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to install ceiling fan on a 3-way circuit [ 2 Answers ]

I want to replace a ceiling light fixture with a ceiling fan w/light kit. The light is on a 3-way circuit. The fan came with a UC-9050T wall remote. What I would like to do is control the fan light kit with the 3-way switches and control the fan with the remote. Is this possible? If so, how? Thank...

The Ok light is flashing, the Flame light is off in the furnace circuit board [ 0 Answers ]

I have a Ruud Silhouette II Gas Furnace. The whole unit is turned off/on by a light like switch. The AC is working, but the heater is not. It appears that no gas is flowing to the burner. The PWR light is on, steady. The OK light is flashing; three times on, then off. The Flame light is off in...

How to install and power a Ceiling Light from a light switch? [ 1 Answers ]

I need to install a ceiling light in our bedroom. I have a single light switch and four outlets. One of the outlets is operated by the light switch. I have the following wires coming into the light switch box: three white wires/capped, three copper ground, three black/capped with a fourth pig...

Trying to Install 2 Motions Sensors in One Circuit [ 3 Answers ]

I'm looking to have two Motion Sensor on one circuit. Long walk and want one sensor at both ends. The Sensor I'm using: http://rikain.com/Manuals/Intruder_alarms/Lynteck/ES34.pdf Also Note the Sensor I'm using allows you to switch it 'off' and 'on' quickly in order to override the sensor and...

Install 240 circuit breaker [ 1 Answers ]

I just install circuit breaker 240 v ,but when I use the meter it can only read 120 v on each pole when I check both pole I don't see any thing in the meter,:eek: why is this happen Thanks

View more questions Search