Ask Experts Questions for FREE Help !
Ask
    ajgm801's Avatar
    ajgm801 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 17, 2011, 07:38 PM
    Maytag Gas dryer lights burns for a few seconds then cliks and the flame shuts off?

Check out some similar questions!

Maytag Dryer heat issue, lights flame and goes out in 20 seconds [ 11 Answers ]

I pulled the high limit heat sensor wires off the top of the housing and connected the purple and red wire together and it works fine. I purchased a new sensor and installed it and same problem, flame goes out in about 15-20 seconds. Also replaced the two coils with brand new parts. Also...

I have a Payne 394GAW that starts and burns for 3 seconds, shuts down and recycles. [ 0 Answers ]

I have a Payne 394GAW (about 1987, no standing flame,electric ignition). Starts fine and burns 3 to 4 secs and recycles. Classic dirty flame sensor problem. I cannot find a flame sensor to clean. I have removed burners and looked throughout. Is it in the ignition assembly? Is there some other flame...

The flame on the water heater only burns for a few seconds and then shuts down. [ 0 Answers ]

I am not currently getting any hot water out of my water heater. The flame comes on and burns for a few seconds and then shuts off. This same patterns then continues to repeat.

Maytag gas dryer SDG3606AWW, no flame [ 1 Answers ]

When the dryer is cool the flame will come on but after 3 or 4 minutes it goes out and will not lite again, the igniter comes on but no flame.

Maytag gas dryer flame on 10 sec per 1 minute. [ 2 Answers ]

I have a Maytag gas dryer, model number DG9800. When turned on the tumbler will rotate, the flame will ignite for about ten seconds, go out for a minute, then reignite. The high limit thermostat is what opens and closes the gas valve. The vent line is clear. It takes a LONG time to dry a load...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.